Italian COLD FOIL by EuroGraf made in Italy  Italian COLDFOIL by EuroGraf made in Italy Cold Lamination System size 102 cm. with 2 TOWERS for your printing press size 70x100 cm. 6 colours + L To be installed in-line the unwind unit is mounted onto the 2° printing group and the rewind unit onto the 3° printing group, and this one can print normally. Good coated paper is necessary. Standard features: The system has: • N. 1 (one) unit with n. 2 (two) servo controlled arms to unwind the foil (to be installed on the second printing group) and n. 1 (one) unit with two servo controlled arms to rewind it (to be installed on the third group); this to allow double web foil to be run at the same tine. • N. 4 (four) pneumatic foil mounting shafts, two for unwind and two for rewind • Touch screen on the machine to operate the units, Proface model or similar • System to allow saving of foil in make ready • Foil shaft lifting beam for you lifting system • Special foil guide rolls for mounted inside the press, to be defined during “site inspection” and related to the printing model and manufacturer, which touch ONLY the rear foil side in order to keep perfect the living side, avoiding foiling spray • End web sensor for unwind unit • End web sensor for rewind unit Included: • All mechanical, electrical and pneumatic fittings and connections • Connecting interface between your printing machine and Cold Foil System • Specific rollers for the mentioned model • Mounting feet to install the units onto the press, size 102, height 300mm about • Property software • 10 meters of interconnecting cables • Electrical control cabinet • CE certification + EuroGraf marks • Instruction manual in your language (English or French) • Technical assistance with specialized engineers and original spare parts Not Included: • Unload by your factory and lifting of the units onto the printing units for the installation • Due crane to lift the foil web • Air compressor. It is needed compressed air 7 bar (100psi), near the machine • Electrical power is required to be delivered to a terminal isolator near the machine: 3 phases, earth and neutral, 380/415 Volt, 50Hz, 60 Amps • Electrical connection to the control cabinet • Supply of a stair to be manufactured related to the printing press, to allow operators to work in security to load and unload web foil Reel size: • Max width of reel 1020mm • Min width of reel 200mm • Core Diameter standard 6” (around 152mm) • Max length of reel around 8000mt * • Max weight of reel around 250kg *